How to change your oil.

Things you will need:
Oil (5 quarts)
Oil pan
Oil filter
A floor Jack
Tools
Rags


Step 1 Jack the car up to get to the oil drain plug. Have your oil pan ready when you take off the oil drain plug.

Step 2 While the oil is draining check and make sure you have the right oil filter. When you have the right oil filter. Dip your finger in the new oil and run your finger around the gasket on the oil filter.

Step 3 After the oil has all drained put the drain plug back in and make sure you don’t over tighten the bolt.

Step 4 Locate your oil filter and unscrew it and put the new oil filter on. Make sure you don’t over tighten it. The oil filter only needs to be hand tight.

Step 5 Locate the oil fill cap. When you have found the oil cap. Pour the new oil in to the motor. Put only 4 and a half into the motor. Then check your oil level. If it is at the full line don’t put any more in. if it is not to the full line add the other half to it.

Step 6 Check and make sure you don’t have any oil leaks. If you don’t you did it right. Now start the car and let it run for a few minutes and then check your oil level if it is still at the full mark you are done. If not add more oil until it reaches the full level.

Step 7 Clean up your tools and your work area.